tune your printer and do a temp calibration tower.
other things that will help with this is increasing extrusion width to 150% or so of the nozzle diameter. (this also improves the strength of your parts.)
that said benchy’s are horribly unstable and don’t float right. but they should float.
tune your printer and do a temp calibration tower.
other things that will help with this is increasing extrusion width to 150% or so of the nozzle diameter. (this also improves the strength of your parts.)
that said benchy’s are horribly unstable and don’t float right. but they should float.
Edit: Also, for your nerdy enjoyment
Did you post the correct link?
apparently not. It’s fixed now.
(the lady who built a not-quite-full-sized benchy)