No affiliation or anything. I’m simply stoked!
Elegoo Rapid PETG. I like PETG, but with my printer (Ender 5 Plus, slightly tuned; DD, All metal hotend, dual gear extruder, accelerometer…) regular PETG is sloooow. I’m already up to 180 mm/s it prints beautifully. As with all PETG it likes to be thoroughly dry. Once dry it prints like a PLA+. Beautiful definition.
I paid about 15€ per roll, but buying a 4 pack, it comes to about 12,50€ per roll, so about the same as PLA.
I’m just not buying regular PLA, or PETG anymore. The new generation of materials just leave the older ones in the dust. I had a few rolls of standard PETG that I had slowly been using up, but I sold the last 2, I couldn’t bear the waiting times.
I’m going to try a bunch of the new modified materials, like ABS plus and HT, ASA plus, and especially Polymaker’s HT-PLA-GF, a glass fiber high temp PLA that can be annealed in boiling water without deformation to withstand temps like 150º. Nuts! They are basically sold out until August, but once back in stock I’m buying the stuff.
Interesting times to be in the hobby.
That sounds like a microplastic water risk. I hope Polymaker did at least give a little shit about the environmental aspect and made sure the material doesn’t leak into the water during the process. Probably still advisable to pour the waste water through a filter afterwards, just like after sanding & cleaning.
YouWe probably leach more microplastics (I’m guessing, no hard data) by using non-stick kitchenware, including oven trays, air fryers, etc… Also much of our packaging is a source of microplastics. Then there are the microplastics we drag into the environment from our car mats, from out fleece jackets, and soooo many of our activities. I’m with you in the desire to reduce microplastics, but let’s be real, if that is such a primary concern to you, you may have the wrong hobby. I’m working on a prototype of a cheap and cheerful enclosure filter, that I will post in one of the model sites,(about 5-6 € including filament, and about 2-3 € for a hepa + carbon filter), but in the end the filter medium will end up in a landfill. There is no practical solution for recycling or removal of microplastics yet, except elimination of as much plastic production as possible.