Do NOT redeem

If the US didn’t make me pay taxes from abroad every year then I’d be fine not voting.

No taxation without representation

Lol freaking autocorrect 🙃

In general, I guess I don’t know, but ours is fine. The drying is weak shit in comparison and I miss our giant American dryer

I think I see what’s going on here.

If you have a combo washer/dryer (common at least where I am in Europe), the lint trap is wet and it uses water to rinse it towards a collection point. I use a paper towel to pull it out each load.

Stærk Stark contrast to separate washer/dryer which will have a dry lint trap in the dryer.

Ed is (to me, and to the poster of this meme) a rational voice in a storm of media knee-bending to corporations and billionaires who are openly hostile to people, the environment, the economy, everything.

He reacts passionately calling them out on their scam. Nice that he’s getting more and more legit attention and media appearances

Det ved jeg godt :)

But it’s fun to show that meme off. Danish numbers are wild. My bad danish gets me mistaken numbers all the time

And the Danes will think you’re talking about 50

I’m confused, since neither Singapore nor Norway are in the Pac NW

deleted by creator

Anyone know where I can read more about this old Chinatown in CDMX? I can’t seem to find non meme posts about it

Some of those that work forces

Man idk that’s a bit heartless. Fuck the US 6 ways to Sunday and fuck giving them a dime in any way, but I still don’t really want planes to crash en masse anywhere

Surely they spend more on upfront design/engineering though

God is a power bottom in the throuple with his son and a ghostly entity

Jesus, I hope they can piece a campaign together in the few remaining months

Update: sorry to be an OP who didn’t deliver. My buddy never made the measurement. I’m hoping he will. Sorry everyone!

This is all I found on their site about it, which aligns but isn’t as much detail as I hoped

With standard and heavy duty foil, it’s perfectly fine to place your food on either side so you can decide if you prefer to have the shiny or dull side facing out.

Okay, my buddy is gonna take foil tomorrow and run it over the profilometer (?) tomorrow and see. I’ll report back with more numbers and less hand waving when I have it

It was a fair few years ago, but yeah, the oxidation on it will be so much smoother than the delta in surface roughness that I doubt it’d make much difference. Lemme reach out to a metallurgist from there and see what he thinks!